Article description:
ESP32 WiFi 16CH module
Already flashed with the latest Tasmota firmware.
It is a 16-bit relay driver module that can be used to implement mobile phones, computers and remote controls.
Supports a programming mode to install your own programs.
Article description:
16 Channel Relais DC 5V / 12V / 24V
It is a 16-channel relay interface card that can be controlled directly from a wide range of microcontrollers such as Arduino (8051, AVR, PIC, PLC, DSP, ARM, MSP430, TTL logic).
The relay is able to control different devices and other equipment with a high energy requirement.
Uses two 8-channel Uln2803Apg Darlington array chips for controlling the relay module.
The maximum circuit value of the relay output is AC250V 10A and DC30V 10A.
Optocoupler with industrial insulation. Strong anti-interference ability. The trigger current is only 3MA.
The display shells for the operating state are used for safe use.
Widespread for all MCU controls, industrial areas, PLC controls, smart home controls.
4 fastening holes for easy assembly.
Hints:
Relays 7 and 10 are always switched when the circuit board is supplied with electricity, which causes a short on/off impulse on the relay when Tasota loads it and switches off again. If the last condition was a, of course it stays.
All 16 channels could be controlled via the following interfaces: serial, webgui, MQTT, http. An Alexa or app control over the outdated friends of friends, but is limited to the first 8 channels.
Technical data ESP32 module:
Model: ESP 32 16-bit relay driver module
Input voltage: DC 5V
Chipset: ESP32 main tax chip
Work temperature: -25 to 80 ° C
Job moisture: 5% - 95%
Size: 45.5 x 40.5 x 12.5 mm
Technical data relay:
Model: DC5V - DC12V - DC24V 16 times relay
Input voltage depending on the model: DC 5V / DC 12V / DC 24V
Size: 176 mm x 90 mm x 17 mm
Weight: 240g
The board contains 10A/250V AC 10A/30V DC relay
Standard interface for control modules (16 IE port, DC5V Out Plus, DC5V Out Ground)